Categories

Contact Online

Home > Tubeless Conversation
 

Tools for the job ahead

Tools for the job ahead

Electrical Tape
Tubeless Rim Tape
Scissors
Tubeless Valve
Tyre Sealant
Sharp Pick

Step One

It's all in the thumbs

It’s all in the thumbs

Use your electrical tape to make a layer of rim tape, making sure all the nipple holes are covered. After the whole rim is covered by one layer of tape, run your thumb along the rim applying a light amount of pressure to push the tape properly onto the rim. Find where the valve hole should be and using your sharp pick push a hole in the tape through the hole in the rim.

It's only a small prick

It’s only a small prick

Step Two

It's tubeless tape Jim, but not as we know it

It’s tubeless tape Jim, but not as we know it

Now you can apply your tubeless rim tape, following the same process as the electrical tape, make one consistent layer all around the rim making sure it is central in the rim well and covering the electrical tape.

Whilst applying the tape you will need to do an inch of tape at a time and apply constant pressure when pushing the tape down. If you don’t do this the tape can get little air pockets underneath and not sit straight in the rim.

And another one

And another one

After applying a full layer of tape once again, using your sharp pick punch a hole through the tape and the valve hole. If the hole needs to be bigger you can get a larger pick and make the hole in the tape bigger or if you’re extra careful use a small file to take away any unneeded tape.

Step Three

Valve is go

Valve is go

Your taped up rim is now ready for the valve. Unscrew the cap and the compression ring, insert the valve into the rim through the tape ( if the valve can sit flush on the tape without any pressure the hole is too big), using the compression ring tighten the valve down into the rim until it is sat nicely on the tape.

Step Four

Tyre on

Tyre on

You can now fit your tyre. Place one side of the bead onto the rim, place the recommended amount of tyre sealant into the bottom of your tyre, then fit the other side of the tyre onto the rim.

Magic milk

Magic milk

You are now ready to pump up your tyre, this step requires either the use of an air compressor from your local garage or bike shop, or what I used which was a 18g CO2 canister. Place the canisters adapter onto the valve making sure it is secure. Now without holding onto the valve or the canister (the canister gets extremely cold) release a burst of gas into the tyre, which should inflate quick enough to form a seal.

Once the tyre is seated and up to your chosen pressure jiggle the wheel around in your hands whilst also rotating it, this will allow the sealant to cover the whole inside of the tyre.

Pump and go

Pump and go

You are now ready to go out and ride, its as simple as peas.

 



Are you looking for an online bike shop that can provide best price, but with top quality? At Q2 Cycling, we offer best carbon wheels, carbon rim, carbon frames and other carbon bicycle parts. Every product is directly from our factories. At the same time, we also offer wholesale,dropshiping, OEM & ODM service.